November 2007

CompuStocx Diablo CSX XAC-1200 2GB Kit DDR2-1200/PC2-9600 Memory Review

With the CSX XAC-1200 2GB kit we would like to take a look at the first DDR2-1200 memory kit from CompuStocx.
CSX Diablo DDR2-1200 / PC2-9600 memory modules are specificated for memory voltages
up to 2.40 V and thanks to the Micron D9GMH chips, this RAM can already operate as
DDR2-1066 / PC2-8500 modules starting from 1.90 Volt.
This high performance DDR2 RAM kit was able to reach nearly the top speed of all modules
tested so far and satisfied ocinside.de with very high overclocking results.
CompuStocx Diablo CSX XAC-1200 2GB Kit DDR2-1200/PC2-9600 Memory Review
Mushkin XP2-6400 2GB kit DDR2-800/PC2-6400 (996523) Memory Review
Mushkin's current XP2-6400 DDR2-800 memory is not only highly overclockable,
but also reasonably priced. The high performance of the DDR2 800 modules exceeds the
expectations and the reason becomes clear with a look under the heatspreader.
Because Mushkin uses the well-known Micron D9GMH memory chips on the tested modules and
these memory chips are also used on high-end DDR2-1200 modules.
Just the maximum allowed memory voltage for the Mushkin XP2-6400 RAM
is a little bit lower with 1.9 Volt up to 2.1 Volt.
But of course, it's well-known that overclocking isn't always within the specifications.
The following review will show you all details about this 2GB kit and
give you an extensive comparison to all memory modules tested so far.
Mushkin XP2-6400 2GB kit DDR2-800/PC2-6400 (996523) Memory Review


 

OverClocked News - News from www.ocinside.de !

Hier geht's auf die deutsche Redaktion ocinside.de Homepage
I don't hold any responsibility for any damage caused by overclocking.
There is always a risk of damaging your hardware.
And your warranty becomes void if you overclock something.
Copyright 1999-2010 by www.ocinside.de !